EP-514: Input Module Concentrator. • Controls 6 inputs and all signals of EP-512 and EP-513 modules. • The inputs are connected internally to negative, so to activate these should be connected to positive. The operating voltage is 24 V DC. • The activation of each input is monitored by a LEO green indicator. • It has a direct input connector for data cable and a TFT terminals output to distribute these signals to the rest die modules of the machine. Although the provision of the wires in this connector is similar to the analog connector EP-510 card, it really is symmetrical to prevent the connection can be exchanged. • It has a "JUMPER" to insert a terminating resistor in the line of RS485 data. By Therefore, whether to overwrite an EP-514 module having the JUMPER placed, it will be necessary JUMPER move that the new pet ra maintain termination module RS485 line. • You can operate autonomously, but are not intended to function without the EP-513 module, because in all cases they are necessary or ~ l; it relays. • You can not operate simultaneously to EP-503 within a single machine. • Only replace the EP-503 weigh module • Linear weigher 1 and 2 and multihead heads of Step by Step. Therefore, the EP-503 module is not obsolet, and will continue to be used existing parts. • To replace an existing module EP-503 in any of the cases indicated must be installed EP-513 and EP-module 514. Furthermore, in the case of step multihead necessary TFT screen that incorporates the EP-533 module inputs / outputs fast, because as seen in the above table, the EP-513 module contains AVAILABLE signals, Download and OUTPUT HOPPER.